MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 179 / 354

214685
167
Revision A
Figure 7.23: Float Indicator Box
4. Loosen jam nuts (A) securing float indicator cable (B) to
both sides of the float indicator bottom support, and
then disconnect the cable from the support.
5. Float indicator cable (B) is routed around three
pulleys (C) in the float indicator box. Remove the cable
and discard.
NOTE:
Pulleys are hidden by other parts in the illustration.
Their approximate location is identified.
6. Examine the new float indicator cable (MD #187658). You will see that it is divided into sections. The longer
covered section (A) should be installed on the left side of the float module, the middle uncovered section (B)
should be installed in the float indicator box, and the shorter covered section (C) should be installed on the right
side of the float module. Installation instructions are provided in the following steps.
Figure 7.24: Float Indicator Cable
A - Longer Covered Cable Section
1788
–
1800 mm (70-3/8
–
70-7.8 in.)
B - Uncovered Middle Cable Section C - Shorter Covered Cable Section
1352
–
1364 mm (53-1/4
–
53-11/16 in.)
SETTING UP AUTO HEADER HEIGHT CONTROL