MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 163 / 354

214685
151
Revision A
Figure 6.80: Left Endshield Latch Assembly
2. Loosen the three bolts (A) on latch assembly (B).
3. Adjust latch assembly (B) to achieve the desired gap
between the front end of the shield and the header
frame. Refer to Table
6.6, page 149 for the
recommended endshield gap at various temperatures.
4. Tighten the three bolts (A) on the latch assembly.
Figure 6.81: Left Endshield Support Tube
5. Tighten the four bolts (A) on support tube bracket (B).
6. Close endshield.
Closing the endshield:
Figure 6.82: Left Endshield
1. Disengage lock (B) to allow endshield to move.
2. Insert front of endshield behind hinge tab (A) and into
divider cone.
PERFORMING PREDELIVERY CHECKS