214685
164
Revision A
Figure 7.16: Optional Two-Sensor Kit
–
Right Sensor
4.
Follow these steps to adjust right sensor voltage:
a.
Loosen sensor mounting nuts (A).
b.
Rotate sensor (B) clockwise to lower the voltage.
Rotate sensor counterclockwise to raise the
voltage.
c.
Check that the right sensor is at the correct high
voltage limit.
d.
Tighten sensor mounting nuts (A).
Figure 7.17: Float Indicator Box
5.
Fully lower the header; the float indicator (A) should
be at
4
.
6.
Check that both sensors are at the correct low
voltage limit.
Summary of Contents for FlexDraper FD1 Series
