MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 110 / 354

214685
98
Revision A
5.6.2 Positioning Transport Lights
Transport lights are located on each outboard reel arm. They are shipped in an inverted position on the inboard
sides of the reel arms.
Figure 5.85: Transport Light
1. Position light (A) perpendicular to header. Light arm
should move with normal hand force yet maintain its
position. If not, proceed to next step.
2. Loosen jam nut (B) on light attachment bolt, and adjust
hex nut (C) as required. Tighten jam nut (B).
3. Repeat above for opposite side.
5.6.3 Crop Dividers
Crop dividers are used to help divide the crop when harvesting. They are removable to allow installation of vertical
knives and to decrease transport width.
Removing Crop Dividers from Storage
Crop dividers are shipped attached to the inboard side of the endsheets. To remove the crop dividers, follow
these steps:
Figure 5.86: Crop Divider Stored on Endsheet
1. Support the crop divider and remove the shipping wire
at the front end (A).
2. Remove bolt (B).
3. Remove the bolt with washer (C) and retain for
installation.
ATTACHING HEADER TO COMBINE