MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 322 / 354

214685
310
Revision A
Setting Preset Cutting Height (New Holland CR Series
–
2015 and Later)
NOTE:
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other pre-2015
New Holland combine models, refer to
7.1.15 New Holland Combines (CR/CX Series
—
Pre-2015 Model Year),
page 290 .
Figure 7.347: New Holland Combine Controls
The console has two buttons used for auto height presets.
The toggle switch that was present on previous models is
now configured as shown at right. MacDon headers only
require the first two buttons (A) and (B). The third button (C)
is not configured.
CAUTION
Check to be sure all bystanders have cleared the area.
To set preset cutting height, follow these steps:
Figure 7.348: New Holland Combine Controls
1. Engage separator and header.
2. Select preset button 1 (A). A yellow light on the button
will illuminate.
3. Raise or lower the header to desired cutting height.
SETTING UP AUTO HEADER HEIGHT CONTROL