MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 351 / 354

214685
339
Revision A
Predelivery Checklist
Perform these checks and adjustments prior to delivery to your Customer. Adjustments are normally not
required as the machine is factory-assembled and adjusted. If adjustments are required, refer to the
appropriate page number in this manual. The completed checklist should be retained by either the Operator or the
Dealer.
CAUTION
Carefully follow the instructions given. Be alert for safety related messages that bring your attention to
hazards and unsafe practices.
Header Serial Number:
Float Module Serial Number:
Table .13 FD1 Series FlexDraper
® ®
/ FM100 Float Module Predelivery Checklist
–
North America
ü ü
Item Reference
Check for shipping damage or missing parts. Be sure all
shipping dunnage is removed.
—
Check for loose hardware. Tighten to required torque.
10.1 Torque Specifications, page 325
Check tire pressure (Transport/Stabilizer Option).
6.2 Checking Tire Pressure: Transport and
Stabilizer Wheels, page 107
Check wheel bolt torque (Transport/Stabilizer Option).
6.3 Checking Wheel Bolt Torque, page 108
Check knife drive box breather position.
6.4 Checking Knife Drive Box, page 109
Check knife drive box oil level.
6.4 Checking Knife Drive Box, page 109
Check float module gearbox oil level.
6.5 Checking Oil Level in Header Drive Gearbox,
page 111
Check hydraulic reservoir oil level before and after
run-up.
6.6 Checking Oil Level in Hydraulic Reservoir,
page 112
Check knife drive belt(s) tension.
6.7 Checking Knife Drive Belt Tension, page 113
Check if reel is centered between header endsheets (with
header in full smile).
6.9 Centering Reel, page 116
Grease all bearings and drivelines.
6.16 Lubricating the Header, page 142
Check side draper tension.
6.14 Adjusting Draper Tension, page 138
Check draper seal.
6.15 Checking Draper Seal, page 140
Check header float.
6.10 Checking and Adjusting Header Float, page
117
Check wing balance.
6.11.1 Checking Wing Balance, page 122
Check reel tine to cutterbar clearance.
6.12.1 Measuring Reel Clearance, page 131
Check auger flighting to feed pan clearance.
6.13 Adjusting Auger to Pan Clearance, page
135
Check the knife hold-down adjustment.
6.8 Checking Pointed Guard Hold-Downs, page
114