MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 96 / 354

214685
84
Revision A
Figure 5.53: Multicoupler Storage
5. Pull handle (A) on the float module to release
multicoupler (B) from the storage position. Remove the
multicoupler, and push the handle back into the float
module to store.
Figure 5.54: Multicoupler
6. Position multicoupler (A) onto the receptacle, and pull
handle (B) to engage the lugs on the multicoupler into
the handle.
7. Pull handle (B) to a horizontal position and ensure
multicoupler (A) is fully engaged into the receptacle.
Figure 5.55: Feeder House Pin
8. Ensure that both feeder house pins (A) are fully
engaged into the float module brackets.
NOTE:
If the pins (A) do not fully engage the float module
brackets, loosen the bolts (B) and adjust the bracket as
required.
9. Tighten bolts (B).
ATTACHING HEADER TO COMBINE