MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 117 / 354

214685
105
Revision A
Chapter 6: Performing Predelivery Checks
This machine has been set at the factory and should not require further adjustments; however, the following checks
will ensure your machine provides maximum performance. If adjustments are necessary, follow the procedures in
this chapter.
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
before adjusting machine.
IMPORTANT:
To avoid machine damage, check that no shipping material has fallen into the machine.
1. Perform the final checks as listed on the Predelivery Checklist (yellow sheet attached to this instruction
–
Predelivery Checklist, page 339 ) to ensure the machine is field-ready. Refer to the following pages for detailed
instructions as indicated on the Checklist. The completed Checklist should be retained by either the Operator
or the Dealer.
6.1 Recording Model and Serial Number
Record the machine serial numbers on the Predelivery Checklist.
Figure 6.1: Header, Left Side Endshield
The serial number plate (A) is located beside the knife drive
motor on the left endsheet.
Figure 6.2: Float Module
The serial number plate (A) is located at the top left side of
the float module.