MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 329 / 354

214685
317
Revision A
Chapter 9: Running up Header
To run up the header, follow these steps:
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine
and remove key before leaving the operator
’
s seat, and always engage safety props before going under
the machine for any reason.
CAUTION
Never start or move the machine until you are sure all bystanders have cleared the area.
Figure 9.1: Float Module Plastic Pan
1. Start combine, raise header fully, and engage safety
props.
2. Stop engine and remove key.
3. Lower plastic pan under float module and check for
shipping materials/debris that may have fallen under
float module draper.
4. Rotate latches (A) to unlock handles (B).
5. Hold pan (C) and rotate handles (B) to release pan.
Lower pan to expose draper.
Figure 9.2: Float Module Plastic Pan
6. Check and remove debris from pan (A) and draper.