GE CARESCAPE, User Manual

Page: 437 / 548

Printing
2. Select the Arrhythmia tab.
3. Select Print on Alarm for the arrhythmias you would like to print.
NOTE
For arrhythmia alarm waveform printing, the printing will
continue until 20 seconds has passed from the clearance of
the last active arrhythmia alarm (e.g., 10 seconds saved data,
arrhythmia alarm du 20 seconds data).
Printing waveforms for other than arrhythmia alarms
The following are the default settings for other than arrhythmia alarm waveform
printouts:
●
The print delay is 10 seconds.
●
The print duration is 30 seconds.
●
The waveform speed is 25mm/s.
Other than arrhythmia alarms that print are the high/low alarms for the following: HR,
Art/ABP/Fem/UAC sys/dia/mean, SpO
2
, and ST.
1. Select Monitor Setup > Printing .
2. Select the Waveforms tab.
3. Choose a value from the Print on Alarm list:
●
No : No alarm waveforms print during an alarm condition.
●
High : Alarm waveforms print during high priority alarm conditions only.
●
All : Alarm waveforms print during any alarm condition.
Setting the print delay
NOTE
Alarm waveforms (arrhythmia and non-arrhythmia) start
by printing 10 seconds of the most recently saved data,
regardless of the Delay setting.
1. Select Monitor Setup > Printing .
2. Select the Waveforms tab.
3. Select a value from the Delay list:
a. 0 s : Manual waveform printing starts with real time data.
b. 10 s : Manual waveform printing starts with 10 seconds of the most recently
saved data first. After that, the real time data begins to print.
Setting the print duration
NOTE
Non-arrhythmia alarms print 30 seconds of waveforms
regardless of the Print Length setting.
NOTE
An arrhythmia alarm waveform continues to print up to 20
seconds after the arrhythmia resolves or a new arrhythmia
has been identified. The length of the event shall determine
the length of the printout.
1. Select Monitor Setup > Printing .
2. Select the Waveforms tab.
2062971-001 CARESCAPE Modular Monitors 437