Digital Equipment DECstation 5000/100 Series, Maintenance Manual

Page: 283 / 392

erl Command
Use the erl command to display or clear the log of the errors
that occurred since the most recent power-up or reset operation.
The erl command format is
erl [ -c ]
To display the current error message log, use the erl
command without the -c option.
To clear the error message log, include the -c option. When
the error log buffer is full, no more messages are added
until the buffer is cleared by the erl -c command.
go Command
Use the go command to transfer system control to a specific
system address.
The go command format is
go
[ address ]
To transfer system control to the address specified in the
last boot -n command, type the go command without the
address parameter. If you omit the address parameter, and
if no previous boot -n command has been issued, the system
ignores the go command.
To transfer system control to the contents of a specific
address, include the
address
parameter. Replace the
address parameter with the address to which you want
to transfer control.
init Command
Use the init command to initialize module hardware.
The init command format is
init
[ slot_number ] [
- m
]
To initialize the entire system, specify the init command
with no additional arguments.
To initialize an individual module, replace the optional
slot_number parameter with the slot number of the module
that you want to initialize.
Console Commands C–21