Digital Equipment DECstation 5000/100 Series, Maintenance Manual

Page: 286 / 392

To display an individual environment variable, replace
variable with the name of the environment variable you
want to display.
restart Command
Use the restart command to restart the system software. For
the restart operation to succeed, the operating system software
must have a restart block set up in memory.
The restart command format is
restart
script Command
Use the script command to create a temporary set of console
commands that run in an order that you specify.
The script command format is
script
name
When you type the script command, replace name with the
name that you are giving the script. Then press Return.
After you press Return, type the commands that you want
to include in the script. Press Return after each command
that you type. Commands can be t or sh commands. Enter
one command per line. When you finish typing the commands
that you are including, press Ctrl-d or press Return twice to
complete the script.
To run the script, use the sh command described later in this
appendix. When you run the script, the commands execute
in the same order as you entered them when you created the
script.
setenv Command
Use the setenv command to change an environment variable.
Table C-2 lists the standard environment variables. When you
change a standard environment variable (except osconsole and
#), the system stores the new value in NVR and uses it until
you use the setenv command to change it again or reset the
NVR with the clear-NVR jumper.
C–24 Console Commands