![background image](http://html1.mh-extra.com/html/club-car/1996-ds-golf-car-gasoline/1996-ds-golf-car-gasoline_service-manual_2626737533.webp)
Page 24-9
E
24
bearing should be replaced if there is wear or pitting on the balls or on the rolling surfaces. Do not
remove the bearing unless it is to be replaced.
FIGURE 24-9
FIGURE 24-10
FIGURE 24-11
FIGURE 24-12
REPLACE SPRINGS
WHICH APPLY A
FORCE OF LESS
THAN 16 OUNCES
0
5
10
15
20
25
30
35
40
45
50
A
B
PRESS
RAM
WEDGE ATTACHMENT TOOL
(CLUB CAR PART NO. 1012812)
BEARING PULLER
(CLUB CAR PART NO. 1012811)
WHEN USING A PRESS TO
REMOVE BEARING FROM
ARMATURE SHAFT, USE AN
ARBOR WITH AN O.D.
OF LESS THAN 5/8"
TO REMOVE BEARING
USE PRESS AND WEDGE ATTACHMENT
TOOL (CLUB CAR PART NO. 1012812) OR
BEARING PULLER (CLUB CAR PART NO. 1012811)
ADUSTING
BLOCK
SEAL PULLER
(CLUB CAR #1012809)
INSERT SEAL PULLER INTO
GUIDE RING APPROXIMATELY
3/4 INCH (19 MM), THEN TURN THE
ADJUSTING BLOCK UNTIL
THE FINGERS OF SEAL PULLER
ARE WEDGED UNDER
THE GUIDE RING.
QUICKLY AND FORCEFULLY
SLIDE THE RAM UP THE
TOOL SHAFT AND AGAINST
THE STOP. REPEAT UNITL
THE GUIDE RING BREAKS
FREE FROM THE SHAFT.
Summary of Contents for 1996 DS Golf Car Gasoline
