Club Car 1996 DS Golf Car Gasoline, Service Manual

Page: 279 / 544

Page 16-11
G
16
8. Install a wave washer on each mounting pin. Make sure that the concave side of the washer faces the
side of the primary weight with the small guide pin protruding from it (Figure 16-12).
9. Install the secondary weights onto the mounting pins with the weight pins on the secondary weights
pointing away from the primary weights. The wave washers should be between the primary and sec-
ondary weights (Figure 16-13).
10. Install white plastic flat washers on each end of the mounting pins and push them against the outside
surfaces of the weights. Center the weights and washers on the mounting pins (Figure 16-14).
11. Install the weight assemblies into the slots in the hub casting (Figure 16-9, Page 16-9). Make sure that
the mounting pin protrudes an equal amount on each side of the weights when the assemblies are in
position (Figure 16-14).
FIGURE 16-14
FIGURE 16-15
PIN SHOULD HAVE EQUAL AMOUNTS
ON BOTH SIDES
INSTALL WHITE
WASHERS ON
EACH SIDE
OF PIN
DRIVE BUTTON
TAKE UP SPRING
PROPERLY
INSTALLED