![background image](http://html1.mh-extra.com/html/club-car/1996-ds-golf-car-gasoline/1996-ds-golf-car-gasoline_service-manual_2626737160.webp)
Page 12-24
12
G
Test Procedure 15 - Disconnected Kill Wire:
1. Place the neutral lock-out cam in the SERVICE position, put the forward and reverse lever in the NEU-
TRAL position, and chock the wheels.
2. Remove the spark plug wire from the spark plug. Using an ignition spark-gap test tool (Thexton 404®
or equivalent), check for correct spark to plug. Adjust the tester probes to approximately to 18,000 volts
(18 Kv) setting. Connect the tester to the spark plug wire, and connect the alligator clip to the top of the
spark plug (Figure 12-29, Page 12-21).
3. Disconnect the engine-kill white/black wire at the bullet connector located by the RPM limiter (Figure
12-34).
4. With the neutral lock-out cam placed in the SERVICE position and the wheels chocked, connect the 6
gauge red wire to the positive post on the battery, then connect the 6 gauge black wire to the negative
post. Turn the key switch to the ON position. In a well-ventilated area, depress the accelerator to start
the engine.
5. If there is a strong blue spark across the spark gap tester tool and the engine begins to run, test the
engine kill circuit for a shorted wire or other failed components in the engine kill circuit (See Testing the
Engine Kill Circuit) (See Warning Below).
6. If there is no spark, or the spark is a faint yellow or white color, test the ignition circuit components.
Test Procedure 16 - Kill Limit Switch:
The kill limit switch is located inside the electrical component box. The accelerator kill switch is the lower of
the two limit switches and has a white/black wire and black wire connected to it.
1. Place the neutral lock-out cam in the SERVICE position, put the forward and reverse lever in the NEU-
TRAL position, and chock the wheels.
2. Check for proper wiring and tight connections.
3. Place the red (+) probe of the multimeter on the common (COM) terminal (white/black wire) of the limit
switch. Place the black (-) probe on the normally open (NO) terminal (black wire) of the limit switch.
• WHEN THE WHITE/BLACK ENGINE KILL WIRE IS DISCONNECTED, THE ENGINE WILL NOT
STOP RUNNING AFTER THE ACCELERATOR PEDAL IS RELEASED. IT WILL BE NECESSARY
TO DEPRESS AND HOLD THE CHOKE COVER CLOSED UNTIL THE ENGINE STOPS RUNNING.
FIGURE 12-34
FIGURE 12-35
WARNING
Club Car
DISCONNECT
WHITE/BLACK
ENGINE
KILL WIRE
RPM
LIMITER
OFF
DC V
DATA HOLD
AC V
AC/DC 500V MAX
250V MAX
KILL LIMIT
SWITCH
NO
COM
LEVER UP
Summary of Contents for 1996 DS Golf Car Gasoline
