Page 13-39
G
13
Oil Screen Installation
1. To install the oil screen, reverse the removal procedure.
BALL BEARING
Removal
1. Remove the oil seal in the crankcase cover (See Oil Seals Below).
2. Place the crankcase cover (1) on a bench with its outside up (gasket surface against the bench) (Fig-
ure 13-85).
3. Using a bearing driver (2) (Part of CLUB CAR Bearing Driver Kit, Part Number 1016416), drive out the
ball bearing (3) as shown.
Ball Bearing Inspection
1. Clean the ball bearing thoroughly in high flash-point solvent and dry it.
2. Spin the ball bearing by hand and check for (A) axial play and (B) radial play. Replace the ball bearing
if it is noisy, does not spin smoothly, or if it has any play (Figure 13-86, Page 13-40).
OIL SEALS
Oil seals are used on both ends of the crankshaft. Any time the crankshaft is removed from the seals,
the seals must be replaced with new ones.
FIGURE 13-84
FIGURE 13-85
• WHEN MAKING TESTS OR REPAIRS, ALWAYS:
- WEAR SAFETY GLASSES OR APPROVED EYE PROTECTION.
- REMOVE KEY.
- DO NOT ATTEMPT TO SERVICE HOT ENGINE OR EXHAUST.
- DISCONNECT BATTERY AS SHOWN (FIGURE 12-1, PAGE 12-2).
- REMOVE SPARK PLUG WIRE.
• BEFORE REMOVAL AND DISASSEMBLY, CLEAN THE ENGINE.
• SEE SAFETY WARNINGS, PAGE 13-1.
• NEVER REUSE AN OIL SEAL. REPLACE THE OIL SEAL WITH A NEW ONE.
3
1
2
1
2
3
WARNING
NOTE
Summary of Contents for 1996 DS Golf Car Gasoline
