Club Car 1996 DS Golf Car Gasoline, Service Manual

Page: 346 / 544

Page 19-30
19B
E
V-Glide Wiper Switch Assembly, Continued:
6. If the ball stud (5) was removed, insert it through the bell crank with the ball facing away from the wiper
switch housing and install the lock nut (7). While holding the ball stud with a wrench, tighten the lock nut
to 4-5 ft.lbs. (5/7 N-m) (Figure 19-15, Page 19-27).
7. Install the brass bolt (9) with the wire terminal, lock washer, and brass nut through the wiper switch
housing (Figure 19-15, Page 19-27).
8. Install the brass nut (3) onto the brass bolt and tighten to 35-45 in.lbs. (4/5 N-m).
9. Adjust the wiper switch. See Page 19-26.
Installing the V-Glide Wiper Switch
1. Position shim plate (29) on the I-beam and then place the V-Glide wiper switch assembly in position on
the shim plate. Install the mounting bolts (26), lock washers (27), and nuts (28) (Figure 19-15, Page
19-27). Make sure the square shoulders on bolts fit squarely into the wiper switch housing. Tighten nuts
to 33-39 in.lbs. (2.0/2.5 N-m).
• MAKE SURE THE WIPER SWITCH ARM ROTATES FREELY IN THE HOUSING. IF THE ARM
BINDS OR STICKS, IT MUST BE REPLACED.
• BEFORE INSTALLING THE WIPER SWITCH IN THE VEHICLE, INSPECT THE HOUSING FOR
CRACKS OR DAMAGE. IF THE HOUSING IS DAMAGED, THE ENTIRE HOUSING WITH FIXED
CONTACTS MUST BE REPLACED.
FIGURE 19-16
• AFTER INSTALLING THE V-GLIDE WIPER SWITCH, MAKE SURE THAT IT IS SECURELY FAS-
TENED TO THE VEHICLE FRAME.
WARNING
CAUTION
BLACK
GREEN
V-GLIDE WIPER SWITCH WIRES
WHITE
ORANGE
YELLOW
GREEN
BLUE
BLACK
WARNING