Club Car 1996 DS Golf Car Gasoline, Service Manual

Page: 293 / 544

Page 17-7
G
17
Governor Disassembly
1. Remove entire governor gear assembly (1-5, 8, 9) (Figure 17-14, Page 17-8), by placing finger under
governor gear (3) and pushing on weights to hold governor sleeve (8) (Figure 17-13).
2. Remove spacer (9) and governor sleeve (8) (Figure 17-14, Page 17-8).
3. Use a press to remove the bearing (1), spacer (2) and governor gear (3) from governor shaft (4).
4. Remove key (5) from governor shaft (4) (Figure17-14, Page 17-8).
5. Remove bearing (1) by tapping on transmission housing with a plastic hammer (Figure 17-14, Page
17-8).
6. Remove two screws (6) from governor arm shaft (18) and remove internal governor arm (7) (Figure 17-
14, Page 17-8).
7. Remove lower retaining ring (14) from governor arm shaft (18) (Figure 17-14, Page 17-8).
• WHEN MAKING TESTS OR REPAIRS, ALWAYS:
- WEAR SAFETY GLASSES OR APPROVED EYE PROTECTION.
- REMOVE KEY.
- DISCONNECT BATTERY AS SHOWN (FIGURE 12-1, PAGE 12-2).
- REMOVE SPARK PLUG WIRE.
• CLEAN TRANSMISSION BEFORE DISASSEMBLY.
• SEE SAFETY WARNINGS, PAGE 17-1.
• DO NOT PRESS AGAINST BEARING OUTER RACE.
• USE CARE WHEN REMOVING LOWER RETAINING RING (14) TO AVOID CAUSING BURRS ON
GOVERNOR ARM SHAFT (18).
FIGURE 17-13
WARNING
CAUTION
CAUTION
HOLD GOVERNOR SLEEVE (8)
IN PLACE BY PUSHING
ON WEIGHTS
WEIGHTS
GOVERNOR
SLEEVE