Page 12-32
12
G
Removing the Bearings
1. Place the wedge attachment tool (Club Car Part No. 1012812) between the bearing and the armature.
Make sure the wedge attachment tool is supporting the inner race of the bearing. If a press is not avail-
able, secure a bearing puller (Club Car Part No. 1012811) to the wedge attachment tool and pull the
bearing off of the end of the armature shaft. Support the armature so that it will not drop when the bear-
ing is removed (Figure 12-46)
2. Discard the bearings.
3. Slide the bearing retainer (32) off of the output end of the shaft (Figure 12-44, Page 12-31).
Removing the Field Coils
1. Remove the retaining nut from each field coil terminal and slide the insulator out of the slots in the
housing. Remove the four pole piece screws from the housing. Remove the four pole set from inside
the housing. Remove the field coils from the inside of the housing (Figure 12-47). See NOTE at the top
of page 12-33.
FIGURE 12-46
FIGURE 12-47
USE A
1/2" SOCKET
OR PIPE
PRESS RAM
USE A 1/2" SOCKET
OR PIPE
SUPPORT
INNER RACE
OF BEARING
PRESS ON
ARMATURE
SHAFT
WEDGE
ATTACHMENT
TOOL
BEARING
PULLER
TOOL
WEDGE
ATTACHMENT
TOOL
NOTE BEARING IS
SECTIONED FOR CLARITY
RETAINING NUT
INSULATOR
FIELD COIL
TERMINAL
HOUSING
FIELD COIL
POLE PIECE SCREW
POLE SET
Summary of Contents for 1996 DS Golf Car Gasoline
