Page 13-19
G
13
2. Using a micrometer, measure the outside diameter of the rocker shaft at several points along its length
(Figure 13-33).
3. If the outside diameter is less than the service limit of 0.4704 inch (11.949 millimeters), replace the
shaft.
Push Rods
1. Support the rod in V blocks at each end of the rod. Position a dial gauge perpendicular to the rod (Fig-
ure 13-34).
2. Turn the rod slowly and read the variation on the gauge.
3. If the push rod is bent more than 0.012 inch (0.3 millimeter), replace the push rod.
CYLINDER HEAD INSTALLATION
1. Installation is the reverse of removal (See Page 13-10).
2. Making sure that each push rod (5) is in place between the rocker arm (3) and the tappet (6) as shown,
put the rocker shaft (2) into the posts through the rocker arm (3) and washer (4) (Figures 13-35 and
13-36).
FIGURE 13-35
FIGURE 13-36
1
4
2
5
2
3
6
Summary of Contents for 1996 DS Golf Car Gasoline
