Page 5-8
5
E
G
REAR BODY INSTALLATION
1. Install the rear body by reversing the removal procedure.
REAR BODY SOUND INSULATION - GASOLINE VEHICLES
Removal Of Insulation
1. Remove the rear body as instructed on Pages 5-5 through 5-7.
2. Inspect the sound insulation foam for integrity and adhesion to rear body.
3. If the insulation is damaged or loose, remove it from the rear body by scraping with a putty knife or with
a wide paint scraper.
Installation of Insulation
1. Be sure that the rear body is thoroughly clean and dry before installing new insulation.
2. Remove the protective backing paper from the insulation’s adhesive surface.
3. Position the insulation on the rear body and press firmly to adhere it.
4. Install the rear body as instructed above.
FLOORMAT
FLOORMAT REMOVAL
1. Remove the brake and accelerator pedals (See Section 6 of this manual).
2. Loosen two screws in the rear body kick-plate (Figure 5-11, Page 5-7) and pull the rear edge of the
floormat from between the rear body and the floor panel.
3. Remove the top edge of the floormat from the overlapping flange under the dash.
4. Lift the mat from the vehicle.
FLOORMAT INSTALLATION
1. Reverse the removal procedure to install the floormat.
• INSTALL THE MOUNTING PADS (ITEM 4, FIGURE 5-13) BETWEEN THE REAR BODY AND THE
SEAT BACK ASSEMBLY.
NOTE
Summary of Contents for 1996 DS Golf Car Gasoline
