Page 13-20
13
G
Cylinder Head Installation, Continued:
3. Slide the washer (4) against the exhaust rocker, and fit the E-ring (1) into the groove in the rocker shaft
(2) (Figure 13-35, Page 13-19).
4. Install cylinder head assembly to engine.
5. Tighten the bolts down evenly with hand.
6. Use a torque wrench to tighten the six head bolts in the sequence shown (Figure 13-37).
7. Increase the torque in four increments of 50 in.lbs. (6 N-m) and then tighten to final torque of 220 in.lbs.
(25 N-m).
8. Adjust valve clearances.
FIGURE 13-37
FIGURE 13-38
• DO NOT TURN ONE BOLT DOWN COMPLETELY BEFORE THE OTHERS. DOING SO MAY
CAUSE THE CYLINDER HEAD TO WARP.
FIGURE 13-39
CYLINDER HEAD BOLT TORQUE SEQUENCE
1
6
3
5
2
4
5
3
1
6
CAUTION
2
6
4
Summary of Contents for 1996 DS Golf Car Gasoline
