8-38
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 8 Troubleshooting the CTS 1300
Managing CTS 1300 Hardware Setup
Figure 8-31
Placement of Easel and Target for Small Racetrack Table
Step 2
In the Cisco TelePresence Administration interface, click the Right radio button.
Step 3
Click Show Camera Target. Red targets appear on the display.
Step 4
Focus the right camera by completing the following steps:
a.
Loosen the focus ring thumbscrew on the lens of the center camera.
b.
Rotate the focus ring until the black plus sign (+) on the target is clearly in focus.
Note
The camera lens has two adjustment rings, one for focus and one for zoom, as shown in
Figure 8-17
. The focus ring is the one that is nearest to the wall.
Step 5
Adjust the camera mounting plate to center the red plus sign (
+
) on the display inside the black plus sign
(+) on the target.
The screws that you use to adjust the camera are shown in
Figure 8-19
. Use a 2.5 mm Allen wrench.
•
Use the top two screws for left and right adjustment.
•
The lower screw for up and down adjustment.
•
The screws in the middle for adjustments on the horizontal plane (rotational).
Step 6
Adjust the camera zoom by completing the following steps:
a.
Loosen the thumbscrew for the zoom ring on the camera lens.
Note
The zoom ring is labeled “W-T.”
b.
Adjust the camera zoom so that the black curved line on the right of the target touches the right edge
of the display screen, as shown in
Figure 8-32
.
c.
After you adjust the zoom, make any required adjustments to the focus with the focus ring.
Note
Because of the position of the target, the target appears smaller and not parallel to the camera.
This view is normal. Participants will appear lifelike after you complete the testing procedure.
Display
206162
Right participant
sitting position
camera target
Alignment
marker
