8-28
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 8 Troubleshooting the CTS 1300
Managing CTS 1300 Hardware Setup
Figure 8-24
Adjusting the Camera Zoom
Step 7
Tighten the thumbscrews for the zoom and focus rings.
Step 8
Click Hide Camera Targets to remove the alignment images.
Step 9
Click the Setup button, then click the Auto Adjust button.
The auto adjust procedure completes. This procedure takes several seconds.
Note
If there is insufficient light, the auto adjust procedure terminates. In this case, add more light to the room
and repeat the auto adjust procedure.
Step 10
Click Done to complete the procedure.
Focusing the Center Camera
To focus the center camera.
Step 1
In the Cisco TelePresence Administration interface, click the Center radio button.
Step 2
Click the Setup button located below the center screen icon.
Step 3
Click Show Focus Targets.
Red and green outline boxes display on the screen, and red and green horizontal bars display on the
bottom of the screen, as shown in
Figure 8-25
. The horizontal bars indicate the sharpness of focus in the
boxes that use the corresponding color. Longer bars indicate a sharper focus.
Step 4
Position the small camera target by completing the following steps:
a.
Place the target on the table one foot from the edge where the participants sit.
b.
Position the target so that the patterns on the target are enclosed in the green box.
Step 5
Position the large target by completing the following steps:
a.
Remove the large focus target from the easel.
b.
Rotate the target 90 degrees.
206357
