10-7
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 10 Troubleshooting the CTS 3010 and CTS 3210
Managing CTS 3010 and CTS 3210 Hardware Setup
Testing Cameras
The cameras are set up successfully when images are centered and in focus on the display screens and
the white balance has been configured. The hardware setup software provides a camera Auto Adjust
feature and a way to use targets to fine-tune the camera’s focus.
Use the information in the following sections to test and troubleshoot the camera for your system:
•
Testing the CTS 3010 and CTS 3210 Cameras, page 10-7
•
Troubleshooting Cameras, page 10-16
•
Related Information, page 10-16
Note
The camera hood comes off. It should be removed and left off until these procedures are complete.
Testing the CTS 3010 and CTS 3210 Cameras
The cameras are set up correctly when images are centered and in focus on the display screens and the
white balance has been configured. The hardware setup software provides a camera Auto Adjust feature
and a way to use targets to fine-tune the camera’s focus.
The following sections describe how to set up the CTS 3010 and CTS 3210 cameras for testing:
•
Starting the Software Setup, page 10-7
•
Adjusting the Zoom, page 10-9
•
Focusing the Camera, page 10-12
•
Attaching the Camera Hood Assembly, page 10-14
Starting the Software Setup
To start the software setup, complete the following steps.
Step 1
Assemble the Large Camera Target.
When you slide the Camera target into the frame, make sure the target is centered in the frame between
the vertical lines at the top and bottom of the target.
