3-10
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 3 Configuring the Cisco TelePresence System
IP Settings
Figure 3-6
CTS IP Settings - DHCP Not Enabled
Step 2
Configure settings for the Cisco TelePresence System uplink to your network using the information in
Table 3-1
as a guide. The Cisco TelePresence System can be configured in the following ways:
•
Pure dynamic—Uses DHCP for everything.
•
Pure static—Uses static settings for everything.
•
Hybrid—Uses static settings for the IP Address, Netmask and gateway, but uses DHCP for name
servers and other options like
Option 150
for the Cisco Unified CM TFTP servers.
Tip
When you make a change in any of the Configuration > IP Settings fields, the Apply and Reset buttons
are activated.
Step 3
Click Apply to register new or modified settings.
Step 4
Click Reset to restore the original settings.
Note
All codecs on the system must be connected and enabled for the factory reset to complete. To register a
device, see the “Optional Hardware” section of the
Cisco Unified Communications Manager
Configuration Guide for the Cisco TelePresence System
.
Table 3-1
IP Settings
Field or Button
Setting
MAC Address:
MAC address of the CTS primary codec. For example,
“ 00:0D:D1:23:45:A1 ”
Host Name:
Host name of the CTS primary codec. For example,
“ SEP000DD12345A1 ”
