6-9
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 6 Troubleshooting the CTS 1000
Managing CTS 1000 Hardware Setup
Figure 6-3
Target Attached to the Tabletop Edge
Step 6
Unfold the large cardboard target.
Step 7
Insert the cardboard into the channels on the frame with the printed side facing the display.
Step 8
Push the target into the frame until the two registration marks on the upper right and left edges match
the ends of the top metal frame. See
Figure 6-3
.
Tip
To identify the corresponding point on the table, you can measure the distance from a side wall to the
center point in the frame then from the same wall apply the measurement to the table.
Step 9
On the edge of the table across from the wall, align the vertical line in the target with the center point in
the frame.
Step 10
Fit the clamp ends of the target fixture over the table top and tighten the screws to secure.
20091
3
