Proximus Forum 500 Series, Руководство по монтажу и пусконаладке

Страница: 100 / 348

Forum Gateway 560 Installation
98
CAUTION!
Static charge can damage electronic devices.
Observe the regulations regarding electrostati-
cally sensitive components.
4. Carefully push the interface card into the corresponding slot. The printing
on the front of the module should be at the top (see illustration in
previous instruction).
Ensure that the backplane plug of the interface card is securely plugged
into the socket on the backplane.
5. Refit the screws to secure the interface card in the 1-12 frame.
6. Plug the desired cables into the corresponding RJ45 sockets on the
interface card. Refer to
Forum Gateway 560 Modules starting on page 115
for information on the pin assignment for each interface card.
7. Cover any unused slots with dummy covers (included in the scope of
delivery).
The dummy covers must be securely screwed to the frame!
8. If you have exchanged the interface card, you will need to reactivate the
slot for this card.
Open the Telephony: Ports: Slots page in the Configurator again. In the
table row listing the card that has been exchanged, click on Start .
9. Observe the LEDs on the card. Information on indicators can be found in
the chapter
Forum Gateway 560 Modules starting on page 115.
Checking the status of the interface cards via the Web console
You can also check the status of the interface cards via the Web console.
1. Open the Telephony: Ports: Slots page in the Configurator .
2. In the Status table row, check whether a green tick is displayed for the
newly installed interface card. The tick indicates that the interface card is
operational.