Proximus Forum 500 Series, Руководство по монтажу и пусконаладке

Страница: 148 / 348

Configuring the Forum 5004/5008/5012
146 Configuration
Remote configuration IP on
H * 1 9 1 *
Z
(system PIN)
#
Remote configuration IP off
H # 1 9 1 #
Please note: The system PIN is preset to “0000” and it is absolutely imper-
ative that the system administrator changes it to prevent unde-
sirable remote maintenance.
In order for the system technician to be able to log into the Forum 5004/
5008/5012, he requires a user name and password. In this case, the solution
would be to configure a “Service” user assigned to the “Administrators” user
group.
Using remote configuration, all Forum 5004/5008/5012 settings (with the
exception of the system PIN) can be edited or updated. New software versions
of the Forum 5004/5008/5012 and the software for the connected system
terminals and base stations can also be installed (see the
System: Firmware
menu in the Configurator ).
For security reasons, settings in the Configurator , Network menu should
only be edited on site to avoid malfunctions or failures in the customer’s LAN
(e.g. due to IP address conflicts).
Forced logoff of another user by the administrator
If the user “Administrator” logs in and another user with administration rights
is already logged in, then the administrator can forcibly log the other user off
in order to configure. This functionality, for example can be used, when
configuring remotely, when a user has forgotten to log out.
In order to forcibly log a user off:
1. The “Administrator” user logs-in with the administration password.
2. They open the Configurator .
A message shows which user is currently configuring the system.
3. The administrator clicks on the Take over config rights button.
The other user can make no further modifications of the configuration.