KW DAVID 613, Руководство по эксплуатации, Страница: 255 / 264

KW Aufzugstechnik GmbH OPERATING MANUAL DAVID-613
DAVID-D613-V125-E 13.04.2021 Page - 255 -
ST
EP
- 6+
(7)
The function of the door override can be checked by acti-
vating in the menu "B16 retraction with open door". When
traveling to the floor, the door override is activated only in
the zone area, which is indicated by the rapid flashing of the
LED "Einf.O.T in the D613.
Additionally (OPTIONAL ) the function "C416 Test UCM zone travel"
can be checked on every floor to trigger the UCM case when leaving
the zone when the door lock is activated.
ST
EP
- 8
The function of checking the inspection direction is initiated
by activating the inspection. The examiner drives the elevator
up and down half a meter to see if it is moving in the right di-
rection.
In the event of deviations in this test, the wiring of the inspec-
tion inspection is checked and, if necessary, corrected. If the
elevator first moves in the right direction but is then stopped
by an open OC, the UP and DOWN signals are incorrectly
connected to the LIMAX33CP-00.
On the LIMAX CP33, the safety circuit is opened at the OC / terminal
2Z - 3 SiKr output. At the D613 control, all LEDs of the safety circuit
now light up red starting at U8.
ST
EP
- 9
The function of checking the inspection limit switches is initi-
ated by activating the inspection. When approaching the in-
spection limit switches at normal inspection speed, due to the
open OC, the cab should come to a stop before the pre-set
stop system triggers. Otherwise a man would be trapped on
the roof or in the pit.
The inspector carries out an inspection trip at normal inspec-
tion speed upwards. OC opens when the upper limit switch
position is overrun and the vehicle comes to style. Control:
Standstill is reached before the position of the
The same thing happens in the down direction. After the cab
has come to the style stand, it should be possible to move the
vehicle in the safe direction to push the correct direction but-
ton.
On the LIMAX CP33, the safety circuit is opened at the OC / terminal
2Z - 3 SiKr output. At the D613 control, all LEDs of the safety circuit
now light up red starting at U8.
ST
EP
- 10
Function of overspeed V-rated (advance solution)
The tester adjusts the elevator control / inverter so that over-
speed can be achieved. It moves in both upward and down-
ward direction and at a speed slightly above the speed ahead.
Check: OC opens when the pre-trip speed is reached and the
engine brake stops the lift.
On the LIMAX CP33, the safety circuit is opened at the OC / terminal
2Z - 3 SiKr output. At the D613 control, all LEDs of the safety circuit
now light up red starting at U8.
ST
EP
- 11
Function of overspeed V-inspection
The inspector carries out an inspection run at an inspection
speed higher than the prefeeling speed in inspection of the
LIMAX33CP-00.
To check: OC opens on reaching the "advance speed inspec-
tion" and the engine brake stops the elevator.
On the LIMAX CP33, the safety circuit is opened at the OC / terminal
2Z - 3 SiKr output. At the D613 control, all LEDs of the safety circuit
now light up red starting at U8.