KW DAVID 613, Руководство по эксплуатации, Страница: 156 / 264

KW Aufzugstechnik GmbH OPERATING MANUAL DAVID-613
DAVID-D613-V125-E 13.04.2021 Page - 156 -
In the parameter pin bolting device is deposited statically the stop in which the pin bolting device is ef-
fective.
PARAMETER : BOLT MOBIL
In the parameter pin bolting device mobility the stops places registered the pin bolting device is active.
PARAMETER: BOLT RETRIEVING
In this parameter you can decide, the releveling is active ( static ).
PARAMETER: BOLT WAKE LOWERING
In this parameter you can adjust the wake. Worth 1000ms.
PARAMETER: BOLT PRESSING WAKE
In this parameter you can adjust the pressing wake. Worth 4000ms.
PARAMETER: BOLT SINKING TRIP
In this parameter you can choose the sinking trip.
The following functions must be programmed:
Input options:
E328: If “1” then pin bolting device actively
E329: Feedback ” pins driven out”
E330: Feedback “ pins driven in”
E364: Button- pins bring in manually (only by Resend/ Inspection and mobile mode)
E365: Button- pins manually drive out (only by Resend/ Inspection and mobile mode)
E366: Negative pressure ( If the value is „0“, the pump must be started in order to generate pres-
sure)
E367: Pressure switch off by lowering onto the bolts (mobile), at low level „0“ switch off
Output options:
A286: If „1“ then pin drive out
A287: If “1” then pin drive in
A313: Pins move: if A286 or A287 = “1”
A314: Pin feedback driven out ( = limit switch E329 )
A315: Pin feedback driven in ( = limit switch E330 )
1.Statically
The bolting device pins are in a firm floor in the shaft. This floor is specified in the menu. If the bolt is
activated as the first it is examined whether the elevator is located in a floor above the pins. Otherwise
a trip is released there and waited until elevator is located in this floor. Now no further calls are accepted.
The bolts drive out. Afterwards the calls are acepted again. All floor underneath the bolts are not any
longer started is valid also for the sinking trip. With inspection and back getting enterprise the driving
commends in driving direction STARTING FROM with reaching the zone switches in the bolt floor are
switched off as long as the bolt is active. The bolting device can be activated or deactivated only in the
image mode.
2. Mobil
Conditions:
1) Only with DSK absolute shaft copying.
2) The zone S71 must be present
Characteristics:
1. If pit bolding device actively then none „ bringing in with open Door” + no releveling
2. If actively and pins bolts given out then no sinking trip except in the case of error.
With the parameter B617- wake lowering knows the disconnection after lowering retarded become. By
the fact it is possible that the rope is easily eased if the cab touches down on the bolts.
The bolting device bolts are at the car and can be driven out in each floor. If the elevator brings in from
downside (putting up) into the floor the elevator holds above concise at the end of the zone. Then the
bolts are driven out and the elevator lower with retrieving speed into the floor.
If the elevator comes from above ( Down direction) in into the floor, it holds above concise at the begin-
ning of the zone. Then the bolt are driven out and the elevator lower with retrieving speed into the floor.
With hydraulic elevator the sinking trip is terminated if the point of concise is reached and run off the