horiba TPNA-500, Инструкция по эксплуатации

Страница: 236 / 261

Troubleshooting
220
Alarm 4 Lack Blank *2 Pure water is not supplied
Check the remaining amount of pure
water in the pure water tank.
-
Alarm 4
Full Drain Tank
*3
Volume of waste liquid
has reached the limit of
tank capacity
Replace the waste liquid tank. -
Alarm 5 CAN Comm.

The CAN
communication cable
is disconnected

The CPU for the sub-
board is abnormal
Contact HORIBA Advanced Techno. -
Alarm 5
CAN Comm.
UV

The serial
communication cable
is disconnected

The CAN
communication cable
is disconnected

The CPU for the UV
meter board is
abnormal
Contact HORIBA Advanced Techno. -
Alarm 5 Lamp P
The LED light source is
abnormal or the light
intensity is low
Contact HORIBA Advanced Techno. -
Alarm 5 Lamp N
The Xe lamp light source
is abnormal or the light
intensity is low
Contact HORIBA Advanced Techno. -
Alarm 5 Lamp UV

The measurement cell
is dirty

Temporary interruption
in illumination from
light source

The output power has
dropped due to
deterioration of the
light source

There is a connection
error inside the
analyzer, or the
detector or board is
faulty

Clean the measurement cell.

The light source may not turn ON
until it has warmed up. Turn OFF the
power and turn it ON again, and then
wait for approximately 30 minutes.

Replace the light source.

Reconnect the cables inside the
analyzer.
-
Alarm 5 Cell Motor

The measurement cell
is dirty

The cell motor for the
analyzer is faulty

Clean the measurement cell.

Replace the motor.
-
Alarm 5
Lo Temp
Machine The equipment internal
temperature is low

Check the temperature data.

Maintain the temperature within the
operating temperature range.
“ INT. ANALOG
INPUT” (page
127)
Alarm 5 Lo Temp Bench

The temperature
sensor for the bench
block is faulty or
disconnected

The temperature
sensor is poorly
secured
Check the temperature data.
Contact HORIBA Advanced Techno.
“ INT. ANALOG
INPUT” (page
127)
Classification
Alarm
description
Possible cause Corrective action Reference