Delta ASDA-B3 Series, Руководство пользователя

Страница: 367 / 815

Parameters ASDA-B3
8-82
8
P2.061 E-Gear ratio (numerator) (N3)
Address: 027AH
027BH
Default: 16777216 Control mode: PT
Unit: pulse Setting range: 1 to (2
29
-1)
Format: DEC Data size: 32-bit
Settings:
Refer to the description of P2.060.
P2.062 E-Gear ratio (numerator) (N4)
Address: 027CH
027DH
Default: 16777216 Control mode: PT
Unit: pulse Setting range: 1 to (2 29 -1)
Format: DEC Data size: 32-bit
Settings:
Refer to the description of P2.060.
P2.063 -
P2.064
Reserved
P2.065 Special bit register
Address: 0282H
0283H
Default: 0x0104 Control mode: PT / PR / S / Sz
Unit: - Setting range: 0 - 0xFFFF
Format: HEX Data size: -
Settings:
7 6 5
4
3 2 1 0
Bit
15 14 13 12 11 10 9 8
Bit
Bit Function Description
Bit 0 - Bit 2 Reserved -
Bit 3
Methods for regenerative
energy consumption
0: determined by the servo’s internal algorithm.
1: determined by the DC Bus voltage.
Bit 4 - Bit 5 Reserved -
Bit 6
Pulse error (pulse
frequency is too high)
protection function in PT
mode
0: enable the function.
1: disable the function.
Bit 7 Reserved -
Bit 8
U, V, W wiring error
detection function
0: disable the function.
1: enable the function.
Bit 9
U, V, W disconnection
detection function
0: disable the function.
1: enable the function.
Bit 10 ZCLAMP function selection
The ZCLAMP function is enabled when all the following
conditions are met.
Condition 1: Speed mode
Condition 2: DI.ZCLAMP is on
Condition 3: motor speed is slower than the value of P1.038