Advanced Energy Paramount MF 2 kW, Руководство пользователя

Страница: 34 / 147

If you are not using the User port to control or monitor the unit, you can use a
“dummy” or “cheater” plug to satisfy these signals, thereby ignoring the User port.
To make a dummy plug, solder these jumpers on a mating connector.
Table 4‑1. Jumpers on a dummy plug to satisfy minimal signal requirements
Jumper Between Pins Description
4 and 13 Connects RF PWR ON pin to +15 V pin
17 and 21 Satisfies RF PWR ON return to ground
10 and 23 Satisfies INTERLOCK LOOP signal
If desired, you can add an emergency off switch in series with the RF PWR ON signal
(pin 4) and/or tie your system interlocks in series with the generator INTERLOCK
LOOP signal (pins 10 and 23).
If the minimum requirements are met and then AC power is applied, RF output will
not automatically be activated. Choose a control mode, and then, to activate RF
output:
• If you are in host control mode, send an RF on command.
• If you are in user control mode, send an RF off signal and then an RF on signal.
25-Pin User Port Signal and Pin Descriptions
The following tables describe the 25-pin User port signals and pin descriptions.
Wiring diagrams are also provided.
Table 4‑2. User port signal descriptions
Description Specification
Digital inputs (DI) Optocouple-insulated
Logic high: 4 V to 25 V, typical input current 11 mA
Logic low: Less than 1 V
Digital outputs (DO) Optocouplers open or close state
Open (high impedance): V maximum = 30 V (IC < 500 μA)
Close (low impedance): I maximum = 11 mA; Voltage drop is
less than:
• 1.2 V at 0.1 mA
• 3.2 V at 5 mA
• 5.6 V at 11 mA
Analog inputs (AI) Voltage range 0 V to 10 V
Advanced Energy
®
Paramount
®
MF 2 kW Generator
57020114-00E Communication Controls 4‑2