![background image](http://html1.mh-extra.com/html/zeiss/humphrey-hfa-ii-i-series/humphrey-hfa-ii-i-series_field-service-manual_3332218510.webp)
FA2i-045A
Page 3
2) Flip the base assembly over onto the casters. Place the lift mechanism onto the base, orienting the
Power Inlet towards the back of the base as shown in Figure 3. Secure with the M5 x 25 SOC HD
CAP Screws / M5 Bell Spring Steel Washers / M5 Flat Washers supplied. Tighten screws with a
4MM Allen (Hex) wrench. Torque to
**
50-55 IN-LB.
Figure 3 Secure the Lift Mechanism onto the Base
**
Note:
50 – 55 IN-LB is equivalent to 5.78 – 6.36 Newton/Meters or 4.17 – 4.58 FT-LB.
3) Place the table support tray on top of the lift mechanism as shown in Figure 4. Secure with the M5 x
25 SOC HD CAP Screws / M5 Bell Spring Steel Washers / M5 Flat Washers supplied. Tighten
screws with a 4MM Allen (Hex) wrench. Torque to
**
50-55 IN-LB.
Figure 4 Secure the Support Tray onto the Lift Mechanism
4x 32336-25
4x 43812
4x 47611
4x 32336-25
4x 43812
4x 47611
Summary of Contents for humphrey HFA II-i series
