Xerox PHASER 8560MFP, Service Documentation

Page: 163 / 296

10/2006
4-49 Phaser 8510/8560MFP Multifunction Product
REP 4.0.10, REP 4.0.11
Repairs and Adjustments Initial Issue
REP 4.0.10 Tray 2 Lift Motor Gear
Parts List on PL 4.0
Removal
1. Remove the Electronics Module (REP 5.0.5).
2. Remove Tray 2.
3. Remove the Lift Motor Gear by prying the Push Nut off the shaft. Replace the Push Nut
with a new one when installing the gear.
Figure 1 Removing the Lift Motor Gear
Replacement
Check that the bushing tabs are properly seated in the chassis. To seat the new Push Nut,
position the Push Nut so the fingers point away from the shaft. Place a 3/8 in. nut driver over
the nut and press firmly to seat the nut on the shaft.
REP 4.0.11 Y-Axis Motor Assembly
Parts List on PL 4.0
Removal
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Left Side Cover (REP 1.0.7).
4. Release tension on the Y-Axis Belt by pulling the end of the Spring Arm toward the front of
the printer.
Figure 1 Removing the Y-Axis Spring
5. Hold tension with one hand while removing the Y-Axis Belt with the other.
6. Remove the Y-Axis Spring using either a spring hook or pliers, Brace the printer to prevent
movement while removing the spring.