Xerox PHASER 8560MFP, Service Documentation

Page: 160 / 296

10/2006
4-46 Phaser 8510/8560MFP Multifunction Product
REP 4.0.5, REP 4.0.6
Initial Issue Repairs and Adjustments
REP 4.0.5 X-Axis Motor
Parts List on PL 4.0
Removal
1. Remove the Right Side Cover (REP 1.0.21).
2. Disconnect the X-Axis Motor (P/J150) from the Right Side Harness.
3. Remove 4 (plastic, T-20) screws that secure the motor to the frame.
Figure 1 Removing the X-Axis Motor
Replacement
Engage the fork extending from the motor shaft to the Side Rail as shown in Figure 1. Also, slip
the mounting plate behind the ground strap and replace the cable retainer on the lower right
screw. Perform the Head Tilt Gear (ADJ 4.13.1), and Process Drive Alignment (ADJ 4.7.1)
adjustments before restoring system power.
REP 4.0.6 Drum Fan
Parts List on PL 4.0
Removal
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Right Side Cover (REP 1.0.21).
4. Disconnect the Drum Fan (P/J118) from the Right Side Harness.
5. Remove 3 (plastic, T-20) screws that secure the fan to the chassis.
Figure 1 Removing the Drum Fan
Replacement
NOTE: Check that the grounding strap contacts the Pivot Plate Shaft following installation.