Xerox PHASER 8560MFP, Service Documentation

Page: 166 / 296

10/2006
4-52 Phaser 8510/8560MFP Multifunction Product
REP 4.0.13, REP 4.0.14
Initial Issue Repairs and Adjustments
Figure 2 Removing the Tray 2 Lift Motor
Replacement
Check that the bushing tabs are properly seated in the chassis. To seat the new Push Nut,
position the Push Nut so the fingers point away from the shaft. Place a 3/8 in. nut driver over
the nut and press firmly to seat the nut on the shaft.
REP 4.0.14 Media Drive Assembly
Parts List on PL 4.0
Removal
NOTE: Do Not completely remove the Tray 1 Pick Solenoid screw. A replacement solenoid is
included with the new Media Drive Assembly. Loosen the screw just enough to allow removal of
the Media Drive Assembly.
1. Remove the Scanner Assembly and attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Left Side Cover (REP 1.0.7).
4. Disconnect the Media Drive Motor (P/J206), Deskew Clutch (P/J256), Tray 1 Pick Clutch
(P/J230), Tray 1 Pick Solenoid (P/J241), and Preheater Lift Solenoid (P/J202) from the
harness.
5. Remove 1 (plastic, T-20) screw that secures the braided ground wire to the Media Drive
Motor mounting plate.
6. Remove 1 (metal, T-20) screw in the Y-Axis Motor mount that secures a ground strap to
the Pick Clutch.