Xerox PHASER 8560MFP, Service Documentation

Page: 74 / 296

10/2006
2-48 Phaser 8510/8560MFP Multifunction Product
39,005.43 , 39,010.8
Initial Issue Error Messages and Codes
39,010.8 Document Feeder Disconnected or Missing
The system could not detect the DADF. The following troubleshooting procedure applies to this
error:
Initial Actions
• Check the DADF connection to the Scanner Assembly.
• If the problem persists, follow the procedure below.
Primary Causes
The troubleshooting table lists parts and wiring referenced in the troubleshooting procedure.
Troubleshooting Procedure
5 Is the Status LED Off? Replace the Scanner
Power Supply (REP
5.0.2). If the error
persists, replace the
Electronics Module
(REP 5.0.5). Go to Step 6.
6 Disconnect the Scanner Assembly from
the Electronics Module.
Does the Status LED light? Replace the Scanner
Assembly (REP
1.0.11). Replace the Exit
Module Control
Board (REP 5.0.1). If
the error persists,
replace the Scanner
Power Supply (REP
5.0.2). If the Status
LED remains Off,
replace the Electron-
ics Module (REP
5.0.5).
Table 2 Scanhead Missing Troubleshooting Procedure
Step Questions or Actions Yes No
Document Feeder Disconnected or Missing Faults
39,010.8 The DADF was not detected. Document Feeder Disconnected or DADH Missing
appears on the Control Panel display.
Table 1 39,010.8 Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
DADF, PL 1.0
Table 2 DADF Disconnected or Missing Troubleshooting Procedure
Step Questions or Actions Yes No
1 Reseat the DADF connection to the Scan-
ner Assembly.
Wait at least one minute.
Does the problem persist? Go to Step 2. Complete.
2 Cycle system power and retest.
Does this correct the problem? Complete. Replace the DADF
(REP 1.0.15).