Xerox PHASER 8560MFP, Service Documentation

Page: 150 / 296

10/2006
4-36 Phaser 8510/8560MFP Multifunction Product
REP 2.0.16, REP 2.0.17
Initial Issue Repairs and Adjustments
Figure 2 Removing the Drum Maintenance Pivot Plate
Replacement
Lightly grease the metal plates on the underneath side of the Pivot Plate using a small amount
of Rheolube 768 grease (P/N 070E00890). Also check that the right end of the Pivot Plate
Shaft is in contact with the Ground Plate following installation of the Drum Fan. Perform the
Head Tilt Gear (ADJ 4.13.1), and Process Drive Alignment (ADJ 4.7.1) adjustments before
restoring system power
REP 2.0.17 Preheater and Deskew Assembly
Parts List on PL 2.0
Removal
1. Open the Front Door
2. Remove the Lower Inner Duplex Guide (REP 3.0.2).
3. Remove the Inner Simplex Guide (REP 3.0.1).
4. Release the lock on the back of the AC connector (P/J0720) and unplug the AC and sen-
sor connector (P/J860) from the bottom of the Preheater.
Figure 1 Preheater Electrical Connections
5. Slide the latches in and forward to release the Preheater as shown in Figure 2.