Xerox PHASER 8560MFP, Service Documentation

Page: 162 / 296

10/2006
4-48 Phaser 8510/8560MFP Multifunction Product
REP 4.0.8, REP 4.0.9
Initial Issue Repairs and Adjustments
REP 4.0.8 Exit Roller Motor
Parts List on PL 4.0
Removal
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Right Side Cover (REP 1.0.21).
4. Disconnect the motor (P/J309) from the harness.
5. Remove 4 (plastic, T-20) screws, one with a ground strap that secure the motor to the
chassis.
Figure 1 Removing the Exit Roller Motor
6. Remove the KL-Clip that secured the pulley on the motor shaft and transfer the pulley to
the replacement motor.
REP 4.0.9 Exit Elevator Motor
Parts List on PL 4.0
Removal
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Left Side Cover (REP 1.0.7).
4. Disconnect the Speaker.
5. Mark the position of the leads and disconnect the Exit Elevator Motor (P/J303) from the
harness.
6. Remove 4 (plastic, T-20) screws, that secure the motor to the chassis.
NOTE: Transfer the Speaker to the replacement motor bracket.
Figure 1 Removing the Exit Elevator Motor
Replacement
If the Elevator Motor leads are reversed during replacement, on power-up, the system enters a
fault state without displaying a fault code. This state is indicated by the LED on the Exit Module
Control Board flashing and media jams in the Exit Module.