Xerox PHASER 8560MFP, Service Documentation

Page: 133 / 296

10/2006
4-19 Phaser 8510/8560MFP Multifunction Product
REP 2.0.2, REP 2.0.3
Repairs and Adjustments Initial Issue
12. Install the Ink Loader.
13. Perform ADJ 4.13.1 to home the Head Tilt Gear.
14. Reassemble the remaining components, and turn system power on.
15. Print the Light Stripes page. Check for jets in Service mode. If necessary, use the Control
Panel to reset the jet substitution.
16. Package the defective Printhead and completed Printhead Checklist in the replacement
part’s packaging.
REP 2.0.3 Drum Assembly
Parts List on PL 2.0
Removal
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Right Side Cover (REP 1.0.21).
4. Remove the Left Side Cover (REP 1.0.7).
5. Remove the Ink Loader Assembly (REP 2.0.1).
6. Park the Printhead using ADJ 2.2.1.
7. Place the Printhead Wiper Blade in its home position using ADJ 2.5.1.
8. Remove the Exit Module (REP 3.0.7)
9. Remove the Drum Temperature Sensor (REP 6.0.4)
10. Remove the Transfix Load Module (REP 2.0.15).
11. Remove the Media Drive Gearbox (REP 4.0.14).
12. Remove the Y-Axis Belt (REP 2.0.4). Relieve tension on the belt by pulling the end of the
Spring Arm toward the front. With the tension released, slide the belt off the pulley.
13. Disconnect the Drum Fan P/J118 from the Right Side Harness and release the fan har-
ness from the retainer on the Process Drive.
14. Remove 3 (plastic, T-20) screws that secure the fan to the Drum. Note the location of the
Ground Plate behind the fan
Figure 1 Drum Fan Mounting