10/2006
viii
Phaser 8510/8560MFP Multifunction Product
Moving the System
Initial Issue
Introduction
Moving the System
WARNING
Parts of the system are hot. To avoid personal injury or damage to the system, allow the
ink to solidify. Run the shut-down procedure to cool the system quickly. Wait at least 30
minutes for the system to cool completely before moving or packing it.
•
Allow the system to cool before it is moved to avoid ink spills which can damage the sys-
tem.
•
Use the shut-down procedure from the Control Panel before moving the system for best
results.
•
Never move the system if you receive a Power Down Error-Head not Parked message at
the system’s control panel. This message means the system is not ready to be moved. If
the printhead is not locked, the system can be damaged during shipment.
•
Always turn off the system using the power switch, located under the interface cover on
the right side of the system, and unplug all cables and cords. Do not turn off the system by
pulling the power cord or using a power-strip with an on/off switch.
•
Always secure the scanhead shipping restraint on the left side of the scanner to lock the
scanhead before removing the scanner portion of the system. Shipping the scanner with
the scanhead unlocked can damage the scanner.
Figure 1 Locking the Scanhead
•
Always remove the document feeder before shipping the system.
•
Always remove the scanner before shipping the system.
•
The system is heavy and must be lifted by two people. The illustration below shows the
proper technique for lifting the system.
Figure 2 System Lifting Technique
•
Always move the system separately from optional Trays 3 and 4.
When shipping the system, repack the system using the original packing material and boxes or
a Xerox repackaging kit. Additional instructions for repacking the system are provided in the
repackaging kit. If you do not have all the original packaging, or are unable to repackage the
system, contact your local Xerox service representative
CAUTION
Failure to repackage the system properly for shipment can result in damage to the system.
Damage to the system caused by improper moving is not covered by the Xerox warranty, ser-
vice agreement, or Total Satisfaction Guarantee.
Summary of Contents for PHASER 8560MFP
