Xerox PHASER 8560MFP, Service Documentation

Page: 156 / 296

10/2006
4-42 Phaser 8510/8560MFP Multifunction Product
REP 3.0.7
Initial Issue Repairs and Adjustments
REP 3.0.7 Exit Module
Parts List on PL 3.0
Removal
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Left Side Cover (REP 1.0.7).
4. Remove the Right Side Cover (REP 1.0.21).
5. Remove the Ink Loader (REP 2.0.1).
6. Remove these components from the right side:
a. Remove the right front (plastic, T-20) screw.
b. Remove the KL-Clip, Pulley, and Belt from the Exit Elevator Roller to access and
remove the right rear screw located behind the large Wiper Assembly gear.
Figure 1 Exit Module Right Side Fasteners
c. Remove the (plastic, T-20) screw connecting the Exit Module and Back Frame.
7. Remove these components from the left side:
Figure 2 Exit Module Left Side Fasteners
a. Loosen the Media Drive Assembly to remove the left front screw. See REP 4.0.14.
b. Remove the left rear screw located behind the large Wiper Assembly gear.
c. Remove 1 (plastic, T-20) screw that connects the Exit Module and ground wire to the
Back Frame.
8. Disconnect these connections. See Figure 3:
• Output Tray Full Sensor (CN801 and CN802)
• Front Exit Module Harness (P/J303)
• Speaker (P/J410)
• Elevator Position Sensor (P/J409)
• Scanner Detect Sensor (CN851)
• Exit Module Harness (P/J308)
• Exit Door Interlock Switch (P/J411)
• Drum Temperature Sensor (P/J870) on the I/O Board.
• Front Door Interlock (P/J140).
• Head Maintenance Clutch (P/J130).
• I/O Board connector (P/J680).