WinGD X82-B, Maintenance Manual

Page: 729 / 841

PROCEDURE
1 Put oil on the new O-ring (005 and 010, Figure 13-9 ).
2 NOTE: The HP fuel pipes are as follows:
• HP fuel pipe (001)
• HP fuel pipe (003)
• HP fuel pipe (004).
Attach the O-rings (005, 010) to the applicable HP fuel pipe (001, 003, 004).
3 Make sure that the claws (007, 013) are correctly attached to the applicable HP injection
pipe.
NOTE: You can adjust the claws with an open-ended wrench.
4 Remove the protection from the sealing faces in the injection valve (006) and the ICU
(012).
5 Make sure that there is distance of Y = 6.0 mm between the ends of the applicable HP
injection pipe and the claws (007, 013).
6 Apply Never-Seez NSBT to threads of the screws (009, 015).
7 Carefully put the HP injection pipe in position in the injection valve (006) and the ICU
(012).
8 Torque symmetrically the four Allen screws (009) to 48 Nm.
9 Make sure that there is a distance of X = 12 mm between the flange (008) and the
injection valve (006).
10 Torque symmetrically the four Allen screws (015) to 48 Nm.
11 Make sure that there is a distance of X = 12 mm between the flange (014) and the ICU
(012).
12 Attach the pipe clamps (002, 016).
13 If necessary, attach the insulation to the applicable HP fuel pipe 001, 003, 004.
X82-B
AA00-8733-01AAA-720A-A
Maintenance Manual HP fuel pipe (fuel rail to injection valve) - install
Winterthur Gas & Diesel Ltd.
- 729 - Issue 001 2020-10