PROCEDURE
CAUTION
Damage Hazard: The surfaces of the cylinder liner and the nozzle tip make a metallic
seal. The seat angles in the cylinder liner and on the nozzle tip are different. Do not use a
gasket between the cylinder liner and the nozzle tip. This could cause damage to the
equipment.
1
Make sure that the sealing surfaces (001,
) are clean and have no damage.
NOTE:
If a component of the lubricating quill is defective, you must replace all
components of the lubricating quill.
Fig 7-15
Sealing surface
2
Apply oil to the threads of the screws (004,
).
3
Attach the lubricating quill (003) to the cylinder liner (001) with the screws (004).
4
Torque the screws (004) to the related value, refer to section
5
Remove the plugs from the pipe (002).
6
Attach the pipe (002) to the lubricating quill (003).
7
Tighten the nuts (005) of the unions.
X82-B
AA00-2138-00AAA-720A-A
Maintenance Manual
Lubricating quill - install
Winterthur Gas & Diesel Ltd.
- 233 -
Issue 001 2020-10
Summary of Contents for X82-B
