PROCEDURE
1
Put the insulation bandage (001,
) around the water channel on the cylinder
liner.
2
Make sure that there is an overlap of approximately 30 mm.
3
Put the plate (003) over the insulation bandage (001).
4
Use the lever chain hoist to attach the tension springs (002).
5
Make sure that there is a clearance of 10 mm between the ends of the plate (003).
Fig 7-10
Insulation bandage
6
Attach the flanges (004,
) (part of the lifting tool) (006) to the cylinder liner
(001) with the screws (002).
7
Operate the engine room crane (007) to lower the lifting tool (006) on to the cylinder
liner (001).
8
Apply copper paste to the threads of the screws (005).
NOTE:
The connection between the lifting tool (006) and the cylinder liner (001)
relates to the engine.
9
Torque the screws (005) to the related value, refer to section
10
Apply oil to all new O-rings.
11
Attach the new O-rings to their applicable positions.
X82-B
AA00-2124-00AAA-720A-A
Maintenance Manual
Cylinder liner - install
Winterthur Gas & Diesel Ltd.
- 223 -
Issue 001 2020-10
Summary of Contents for X82-B
