PROCEDURE
1
Clean the seating surface of the bearing shell.
2
Attach the bearing shell - crank pin (008,
) to the console frame (004) with
the four screws (006).
3
Clean the seating surface of the connecting rod and the bearing shell (008).
4
Attach the spur-geared chain block (010) to the sling (011) and to the console frame
(004).
5
Operate the chain block (0 10) to lift the console frame (004) into position.
6
Attach the spur-geared chain block (002) to the console frame (004).
7
Remove the chain block (010).
8
Put oil on the surface of the bearing shell (008).
9
Operate the lever chain hoists (002) move the console frame (004) and bearing shell
(008) into position.
NOTE:
Make sure that the distance between each end of the bearing shell and the
connecting rod is the same.
10
Attach the bearing shell (008) to the connecting rod with the two screws (007).
11
Remove console frame (004).
12
Make sure that the surface of the crank pin is in a satisfactory condition.
13
Put oil on the crank pin.
X82-B
AA00-3303-03AAA-720A-A
Maintenance Manual
Connecting rod - install the bottom end bearing
Winterthur Gas & Diesel Ltd.
- 404 -
Issue 001 2020-10
Summary of Contents for X82-B
