PROCEDURE
1
For the maintenance of the turning gear (001,
), refer to the manufacturer’s
instructions.
2
Examine the items that follow:
•
Condition of the tooth flanks of the gear wheels
•
Lubrication of the pinion (002)
•
Lubrication of the flywheel (003).
Fig 8-14
Turning gear and gear wheels
3
If the tooth flanks have a minimum of lubricant remaining or are dry, continue the
procedure.
4
If you use Klüberfluid as lubricant, prepare the lubricant as follows:
4.1
Put an applicable quantity of Klüberfluid into a container.
4.2
Put the container into warm water until the Klüberfluid is at approximately 35°C.
5
Apply a thin layer of lubricant to the teeth (001) of the flywheel and of the pinion as
shown in
.
X82-B
AA00-3206-00AAA-240A-A
Maintenance Manual
Turning gear - lubricate the teeth
Winterthur Gas & Diesel Ltd.
- 361 -
Issue 001 2020-10
Summary of Contents for X82-B
