) in position at No. 2 and No. 5 bearings.
17
On the two supports (004, 005), tighten the nuts (003, 006).
18
NOTE:
Make sure that the camshaft stays in position before you remove the last
bearing cover.
Remove the remaining bearing covers and top bearing shells at positions No.2 and
No.#, refer to
19
Remove the screw-jack (002).
20
Carefully move the camshaft (007) and the gear wheel (001) on to the two supports
(004, 005).
21
Make sure that the camshaft (007) and gear wheel (001) do not move.
22
Make a mark on the remaining bottom bearing shells to identify their positions. This will
help you when you install the bearing shells.
23
Remove the remaining bearing shells.
Fig 10-31 Camshaft - remove
CLOSE UP
•
Install the camshaft and bearing shells, refer to
10.7.3 Supply unit camshaft and bearing
X82-B
AA00-5581-01AAA-520A-A
Maintenance Manual
Supply unit camshaft and bearing shell - remove
Winterthur Gas & Diesel Ltd.
- 606 -
Issue 001 2020-10
Summary of Contents for X82-B
